+38 (067) 466-38-60
+38 (044) 371-64-52

Spot LED lamp LED-POINT-08

  1. Main
  2. LED-based illumination
  3. Interior LED Lighting
  4. Spot LED lamp LED-POINT-08
точка12

Spot LED lamp LED-POINT-08 built-in type designed for general and decorative lighting interior.

Specifications:
Product: LED-POINT-08
Rated current: permanent, 350m
Power consumption: 1W
Number of LEDs: 1
Luminous efficiency: up to 150 lm/W
Luminous flux LEDs: to 150lm
Angles of radiations: 170, 80 degrees
The curve of luminous intensity (CIL): D, G
Color index CRI: 80Ra
Light color: warm white, cool, red, orange, yellow, green, pink, blue, blue
LED: OSRAM (Germany)
Degree of protection: IP20
Luminaire efficiency: 100%
Temperature operating range: from -40 ° C to + 50 ° C
Overall dimensions: D80х25
Corps: metal, color: matt chrome
Application transparent fluted glass
Life settings: 100000 h.
Guarantee: 18 month.
Certificates of conformity:
  • Lamp meets specifications 31.5-31517453-004: 2009
  • Certificate UkrSEPRO number UA1.035.0132989-10
  • GOST R Certificate of Conformity № ROSS UA.AB41.H00103
LED lighting is-
  • saving electricity 5-10raz!
  • high light output
  • high color rendering
  • high strength and vibration
  • no inrush currents and instant inflammation
  • no stroboscopic effect
  • long life
  • small heat
  • resistance to low temperatures
  • resistance to surge
  • ecological safety

Ltd. Electronic Light, on request, produces svetotehnycheskuyu custom products using LEDs. Or ... you can make an LED lamp itself, applying special LED modules for spotlights!

Requirements for the installation of LED lighting / modules.
Respect the polarity:

Failure polarity connection possible failure of the LED. In the LED of the negative opinion under the lens visible point. To properly connect the LED lamp (module) have special connectors that are installed in each luminaire (modules) and the power supply.

схема подкл схема подкл2
Compliance with the number of LEDs in the garland:

Failure to set the number of LEDs on a specific model of power supply, is the failure of the source and / or LED. One lamp (module) can be set one or more LEDs. When you connect lamps (modules) to a specific source is necessary to determine the number of LEDs in a luminaire.

On the power supply CS 31350 may establish at least 1 and no more than 9 LEDs.

On the power supply JA-80350M possible to install at least 10 and up to 24 LEDs.

In the case of lamps (modules) with red or yellow LEDs must increase the number of diodes in half for each power supply

It is prohibited to include 220V power source connected to it without lighting (modules).

Compliance temperature conditions:

If overheating over the permitted limit in reduced lifetime of LEDs and possible failure.

LED module must be installed using termostrichky surface with good heat sink.

Order form